Call 888-681-1768 | 8AM - 5PM ET M-F
Description
This 10 AWG 3 conductor tray cable with ground is a general purpose 600 volt non shielded control cable designed for power, control and lighting circuits where the benefits of cross-lined polyethylene and its flame retarding properties are needed. It is suitable for a broad range of commercial and industrial uses. This cable is referred to as both XLPE and XPTC.
The Exposed Run (ER) rating on this cable means it meets crush and impact testing requirements, and is therefore tough enough to run outside a cable tray without additional protection, unlike standard tray cables which must be installed inside a conduit, raceway or other protection.
Applications:
- In free air, raceways, and direct burial
- In wet or dry locations
- Approved for direct burial
- Class 1, Division 2 industrial hazardous locations per NEC
Standards:
- UL Type XHHW-2, VW-1 conductors
- IEEE 1202/CSA FT4
- Meets cold bend test of -25C per UL 1277 Section 15
- Rated for UV/sunlight resistance
- * UL 1277 Type TC-ER for 3 or more conductors
Construction:
Conductor:
Fully annealed stranded bare copper per ASTM B3
Class B stranding per ASTM B8
ICEA color code Method 1, Table E-2: black, red, blue
Ground:
Stranded bare copper per UL 1277
Insulation:
Crossed-linked Polyethylene (XLPE) XHHW-2 per UL 44
Jacket:
Lead-free, flame-retardant, sunlight-resistant Polyvinyl Chloride (PVC) per UL standard 1277
Spec sheet available here.
